To measure wheel offset, lay the wheel face down, set a straightedge across the back edge and measure down to the mounting face, which gives you the backspacing. The offset is the backspacing minus half of the wheel's overall width, and you multiply that by 25.4 to get millimeters.
Before you get the tape out, look the wheel over, because the offset is usually stamped or engraved on it, often as ET and a number. If you can find ET35 on the wheel, the offset is +35 mm and you're done.
What you need
You need a tape measure or ruler and something flat and stiff that's longer than the wheel is wide, like a level or a length of straight bar. It's easiest with the tire off the wheel, since you're measuring from the edge of the rim itself.
The four steps
- Measure the overall width of the wheel from outer edge to outer edge. This comes out about one inch more than the size the wheel is sold as, so a wheel sold as 9 inches wide measures about 10.
- Divide that number by two. That's how far the centerline is from the back edge.
- Lay the wheel face down, put the straightedge across the back edge, and measure straight down from the straightedge to the flat face where the wheel bolts to the hub. That's the backspacing.
- Subtract the centerline from the backspacing, then multiply by 25.4. If the answer is positive you have a positive offset, and if the backspacing is the smaller number the offset is negative.
| Step | Wheel sold as 9 inches wide | Wheel sold as 11 inches wide |
|---|---|---|
| Overall width | 10 in | 12 in |
| Centerline (half of that) | 5 in | 6 in |
| Backspacing you measured | 6 3/8 in (6.375) | 5 3/16 in (5.1875) |
| Backspacing minus centerline | +1.375 in | -0.8125 in |
| Times 25.4 | +34.9 mm, so the wheel is a +35 | -20.6 mm, so the wheel is a -20 |
Wheel makers round to the nearest common offset, which is why 34.9 is sold as +35. If your number lands a millimeter or two off a round figure, that's normal for a tape measure.
Why the listed width and the measured width are different
The width in a wheel's size, the 9 in 18x9, is measured on the inside between the two bead seats where the tire sits, and so is the diameter. The outer edges of the rim add roughly half an inch per side on top of that. That's why you use the overall width for the offset math, and it's also why you can't hook a tape over the outside of the lips and read the size off directly.
Where to go from here
Once you have the offset and width of the wheels on the car, you can compare them with any wheel you're looking at. The offset and backspacing calculator will check your math, and the wheel fitment calculator shows how much further in or out a new size will sit. If you're still sorting out which number is which, read the difference between offset and backspacing, and if you also need the lug layout, here's how to measure bolt pattern.
Where is the offset stamped on a wheel?
The offset is usually stamped or engraved on the wheel, often as ET followed by a number. If the marking is missing or you can't read it, measure the backspacing and work the offset out from that.
How do you measure wheel width?
Wheel width is measured on the inside, from one bead seat to the other, and that's the number in the wheel's size. If you measure across the outer edges you'll get about an inch more.
How do you turn backspacing into offset?
Subtract half of the wheel's overall width from the backspacing, then multiply by 25.4 to get millimeters. A 10 inch overall wheel with 6 3/8 inches of backspacing is a +35 offset.